Panel Cover - Take 2

Brian and I decided a while back that we wanted a really clean and sleek looking panel. Screws and what not in an otherwise nice panel drive me crazy. So, I decided that I would make a thin fiberglass panel cover that would be removable and hide all of the screws and rivet heads. My first attempt at it turned out OK. It would have worked but my fiberglass skills were very beginner and it needed a lot of work to finish it off. I talked Brian into letting me remake it because I knew that I could do a much better job than I did a few months ago. This second attempt was well worth the effort. It's super thin & light and it isn't going to require a ton of finishing work. +1 for blossoming fiberglass skills!

Comments are closed